MARCH 2016


AFRIKABOT PARTS KITS

To build the P1X8 AfrikaBot controller you may require some or all of the parts further down this page.

This is what the AfrikaBot controller looks like:



The parts for the AfrikaBot are available from www.mantech.co.za.

You will need a reasonable quality soldering iron. DO NOT use a cheap hardware store grade soldering iron.

You MUST watch the following two videos more than once [each] in order to avoid mistakes in order to get your control board built properly and not destroy the printed circuit board and parts.











THE FOLLOWING PARTS AND/OR KITS ARE AVAILABLE FROM www.mantech.co.za:


OEM Parallax Basic Stamp 2 microcontroller
[also known as the AfrikaBot P1X8 controller]



AfrikaBot printed circuit board [track side]



AfrikaBot printed circuit board [component side]



AfrikaBot parts for printed circuit board
[If you already have bought the printed circuit board]



AfrikaBot parts for printed circuit board closeup
[If you already have bought the printed circuit board]



AfrikaBot parts for printed curcuit board and printed circuit board



AfrikaBot parts for printed curcuit board and printed circuit board closeup



All the electronics to make your AfrikaBot



All the electronics to make your AfrikaBot closeup



Complete kit to build your AfrikaBot
[Including electronics sidecutters, pliers and chassis kit]



Complete kit to build your AfrikaBot
Including electronics sidecutters, pliers and chassis kit






MORE AFRIKABOT RESOURCES











page bottom sponsor logo